Hardware: Software:
Tools table
The tool table is designed to compensate for the length and/or diameter(if supported) of cutting tools.

EDIT - edit a tool from a table
ADD - add new tool
DELETE - delete a tool from the table
SET TOOL OFFSET - set the current value of the machine coordinate Z as an offset in height (tool length)
MEASURE DIAMETER - measure the actual diameter of the tool
LOAD - load a tool / run macro M168
UNLOAD - unload a tool / run macro M169

tool - tool number
cell - number of the cell in which the tool is located

Dnominal - nominal diameter of the tool
Dmeasured - measured diameter of the tool
HOFFSET - tool offset Z axis / tool length

• Documentation • Terms & Conditions • Support • Contacts
Write a message
Copyright © 2023 ViS motion